[MHml] new beam needs net attachments

[Bill Gibbs]

I could glue a SS rub strake top and bottom, or even thin SS sheet metal, if
I was lashing net-net over and under the beam.  
It will be laterally tighter if I lash directly to the beam, half the span
and all.

We lace shed 80 pvc pipe along the net edge, and use spectra for lashing
(1/4"?)

Bill
AB


-----Original Message-----
From: multihulls-bounces at steamradio.com
[mailto:multihulls-bounces at steamradio.com] On Behalf Of Bill Gibbs
Sent: Friday, August 28, 2009 9:38 AM
To: 'Informed discussion of multihull issues'
Subject: Re: [MHml] new beam needs net attachments

Yes, I could, but I'm concerned about chafe on the beam.  Where we have gone
around an alloy beam, the paint is gone and we get corrosion problems.

Bill

-----Original Message-----
From: multihulls-bounces at steamradio.com
[mailto:multihulls-bounces at steamradio.com] On Behalf Of Dan Streeter
Sent: Friday, August 28, 2009 9:23 AM
To: Informed discussion of multihull issues
Subject: Re: [MHml] new beam needs net attachments

I don't have a good picture of your net configuration but 
could you just lash to the beam?


_______________________________________________
Alter your subscription details or unsubscribe at the bottom of this page:
http://www.steamradio.com/mailman/listinfo/multihulls

Multihulls mailing list      (Multihulls at steamradio.com)



_______________________________________________
Alter your subscription details or unsubscribe at the bottom of this page:
http://www.steamradio.com/mailman/listinfo/multihulls

Multihulls mailing list      (Multihulls at steamradio.com)